◴ Oddly .

Home Nature Did It First

Mussels Showed Chemists How to Make Glue That Works Under Water

A mussel's glue is not especially strong, but it holds in crashing salt water, and copying its chemistry has given labs glues that set under water.

Dark blue mussels packed tightly together on a wet seaside rock, fine golden threads visible where they hold on, with a white wave breaking behind them.

On a rocky shore at low tide, the stones are often covered in dark blue mussels, packed so tightly that they look like a cobbled street. Waves have been crashing over them all morning, and when the tide comes back they will crash over them all afternoon. Hardly a single mussel will be washed away. Look closely at the gap between a mussel and its rock and you will find no blob of cement. Instead there is a little beard of fine golden threads, called the byssus, and each thread ends in a tiny flat pad pressed onto the stone, like a tent held down by its guy ropes.

Why water ruins ordinary glue

Anyone who has tried to put sticky tape on a wet bathroom tile knows the problem. Glue works by getting very close to a surface, and water gets there first. People who design adhesives have long treated water as a contaminant: a thin, weak layer that sits between the glue and the thing it is meant to hold. A glue that works in the sea has to grab the rock more firmly than the water already clinging to it.

What people often get wrong

It is tempting to imagine mussel glue as the strongest glue on Earth. It is not. In a 2011 review in the Annual Review of Materials Research, scientists from the University of California, Santa Barbara and Northwestern University estimated that a single pad holds at about 6 megapascals, and they called that not particularly impressive for a high-performance adhesive. Plenty of glues from a hardware shop do better on a dry kitchen table.

What makes the mussel remarkable is where it manages it: in salty, moving water, on rocks coated in slime, again and again. The same review describes how much work goes into staying put. The threads are made one at a time, and a California mussel takes a pull of about 300 newtons to lift straight off its rock, roughly the force needed to pick up a 30-kilogram bag.

One mussel's anchor
  • 50–100 threads holding an average mussel at any one time
  • 3–10 min to make a single thread
  • 8–12% of a mussel's energy spent on its anchor
  • ≈300 N pull needed to lift a California mussel off its rock

The mussel's chemical trick

The secret is in the proteins the mussel's foot squeezes out as a liquid, which then set into a thread and a pad within minutes, a little like plastic being moulded in a factory. Like silk, the finished threads contain no living cells. The proteins are packed with an unusual building block called Dopa, which carries a chemical group known as a catechol. Catechols can cling to wet stone and metal in several different ways at once, and the whole pad is finished with a tough outer coat made of protein and iron.

From the seashore to the lab

Copying the trick has kept chemists busy for decades. In 2015 a team at UC Santa Barbara built a small, single-ingredient molecule that mimics the mussel's foot proteins. It coats a surface in water by arranging itself, with no harsh solvents, heat or light, and it stuck under water up to ten times better than earlier materials of its kind. The researchers suggested uses from repairing things that spend their lives in salty water to dental work, and other groups have added catechols to all sorts of synthetic materials to make glues, sealants and coatings.

None of this has replaced the tube of glue in your drawer, and the mussel does not mind. It simply goes on making one thread at a time, spending around a tenth of its energy on holding tight. Next time you see a rock carpeted in mussels after a storm, you are looking at one of the oldest wet-glue workshops there is.

Sources

Where the facts in this piece come from. Each link leads to another website.

  1. Annual Review of Materials Research (via PMC) — Mussel-Inspired Adhesives and Coatings (pmc.ncbi.nlm.nih.gov)
  2. UC Santa Barbara — A Sticky Breakthrough (news.ucsb.edu)

Found an error?

Tell us what is wrong and, if you can, where the correct information is published. We check every report, and when we fix an article we say so here and on the corrections page.

Write to [email protected] · All corrections

Based on real facts. This piece describes real, documented facts and was written with the help of AI. AI can get details wrong, so check anything important with a trusted source, and tell us if you spot a mistake. More →

You might also like